There are three types of tumble dryer and the difference between them is mostly about what happens to the moisture and how much energy it takes to get it out. That has a large effect on running costs, which over the life of the appliance usually matters more than the purchase price.
How does a vented dryer work?
It heats air, passes it through the drum, and blows the resulting warm damp air out through a hose to the outside. It is the simplest design, the cheapest to buy and the fastest to dry, and it needs either a permanent vent through a wall or a hose run to an open window.
The drawback is efficiency. All the heat generated goes straight outside, so running costs are the highest of the three. They also need a suitable external wall, which rules them out in many flats and internal utility rooms.
How does a condenser dryer work?
It also heats air and passes it through the drum, but instead of venting it, it cools the damp air so the moisture condenses and collects in a tank, which you empty. No external vent is needed, which makes them far more flexible about where they can go.
Running costs are broadly similar to a vented model, sometimes slightly higher. They also warm the room they are in, which is either a benefit or a nuisance depending on the space. The tank needs emptying after most loads, though many can be plumbed into a drain.
How does a heat pump dryer work?
It uses the same principle as a fridge in reverse, recycling the heat rather than generating it fresh. Warm damp air from the drum is cooled to remove the moisture, then reheated and sent round again. Because the heat is reused, it uses roughly half the energy of a condenser or vented dryer, sometimes less.
The trade-offs are a higher purchase price, longer cycle times, and a lower drum temperature, which is gentler on clothes but slower. For most households the running cost saving outweighs the price difference within a few years of regular use.
Which should you buy?
- Heat pump if you dry several loads a week and intend to keep the machine for years. The efficiency gain is substantial.
- Condenser if you dry occasionally, cannot vent outside, and want a lower upfront cost.
- Vented if you have a suitable external wall, want the fastest cycles and the cheapest purchase, and dry infrequently.
What about washer dryers?
They are the right answer when space genuinely does not allow two machines, and a compromise in every other respect. The drying capacity is typically half the washing capacity, so a full wash load has to be split before drying. Cycles are long, efficiency is poor on older condenser based models, and a fault takes out both functions at once.
Heat pump washer dryers have improved matters considerably and are worth looking for if a combined machine is unavoidable.
What should you look at besides the type?
Capacity, which should match or slightly exceed your washing machine, since clothes need room to tumble. Sensor drying, which stops when the load is dry rather than running a fixed time and is both gentler and cheaper. Reverse tumble, which reduces tangling on long items. And the noise rating, which matters a great deal in an open plan kitchen.
Does the energy label tell you everything?
It is the most useful single figure, and heat pump models occupy the top of the scale for good reason. The label quotes annual consumption based on a standard number of cycles, so it is worth scaling that to your own use before drawing conclusions. A household drying two loads a week will see a much smaller absolute saving than one drying eight, even though the proportion saved is identical, and that changes whether the higher purchase price is worth paying.