Mould grows where a surface stays damp. In most homes that means condensation, which happens when warm moist air meets a cold surface. Preventing it therefore comes down to two things: putting less moisture into the air, and keeping surfaces warm enough that the moisture stays in the air rather than condensing on them.
What produces the moisture?
- Drying laundry indoors – a litre or more per load.
- Showering and bathing.
- Cooking, particularly boiling without a lid.
- People, who release a substantial amount overnight simply by breathing.
- Unvented tumble dryers.
- Aquariums and large numbers of houseplants, to a lesser degree.
A household of four generates a surprising quantity of water vapour daily, and in a sealed modern house there is very little natural ventilation to remove it.
What are the daily habits that matter?
- Open windows wide for ten to fifteen minutes each morning, which exchanges the air with very little heat loss.
- Run bathroom and kitchen extractors for fifteen to twenty minutes after use, with the door shut.
- Put lids on pans while cooking.
- Pull the bedding back on waking rather than making the bed immediately.
- Do not dry laundry indoors without ventilation or a dehumidifier.
- Leave trickle vents open.
- Wipe condensation off windows and sills each morning.
None of these costs anything and together they make a substantial difference.
Why does steady heating help?
Because condensation depends on surface temperature rather than air temperature. Heating a room hard for an hour warms the air and leaves the walls cold, and that warm air then holds more moisture which condenses on the cold surface.
A lower temperature maintained through the day keeps wall surfaces above the dew point and frequently costs no more than intermittent heating, because the house is not repeatedly being brought back up from cold.
What about furniture against external walls?
It is one of the most common causes of a mould patch. A wardrobe or a sofa against an external wall insulates that section from the room heat, so the surface behind it stays several degrees colder and condensation forms where no air can move.
Pull furniture five to ten centimetres off external walls. It is free and it resolves a surprising proportion of recurring patches.
Is a dehumidifier worth it?
In a persistently damp house, yes. It addresses the actual limiting factor rather than a symptom, and keeping relative humidity below about 60 per cent makes conditions unsuitable for most mould.
A compressor model suits a heated house; a desiccant model works better in a cold space such as a garage or an unheated room. Both double as the best way to dry laundry indoors.
A cheap humidity meter is worth buying alongside one, since it removes the guesswork.
What about ventilation systems?
Positive input ventilation, which introduces filtered air from a loft unit, is widely used for condensation problems and can be effective in the right house. Continuous low rate extract fans in bathrooms and kitchens are another option and are now standard in new build.
Both are worth considering where the habits above have been adopted and the problem persists.
What about insulation?
It addresses the cause directly, since a warmer wall surface does not reach the dew point. Cavity fill, internal insulated plasterboard or external wall insulation all reduce condensation substantially in a house with cold solid walls.
It needs doing properly. Badly detailed insulation can create new cold bridges at junctions and simply move the problem.
What if none of it works?
Then the moisture is probably coming from the building rather than from the household. A leak, a failed damp proof course, defective pointing or blocked underfloor ventilation will all keep producing damp regardless of how the house is used, and an independent survey is the right next step.
Which rooms need the most attention?
Bathrooms and kitchens produce the most moisture and usually have extraction. Bedrooms produce a surprising amount overnight and rarely have any, which is why they account for a large share of domestic mould despite being the least obviously damp rooms. A bedroom on an external corner, used by two people with the door and window closed, is the highest risk room in most houses.