Back to Products

How Do You Clean a Vacuum Brush Bar?

How Do You Clean a Vacuum Brush Bar?
Cleaning Guides Team 17 July 2025

The brush bar agitates carpet fibres so that dirt sitting below the surface is released into the airflow. When it stops turning, the vacuum still has suction but pick up on carpet falls sharply, and the usual cause is hair and thread wrapped tightly around it.

How do you know it needs doing?

  • Visible hair wrapped around the bar.
  • The bar not turning when the machine is running on carpet.
  • A burning rubber smell, which suggests the belt slipping.
  • Poor pick up on carpet despite normal suction.
  • A change in the noise the machine makes.
  • Bristles that look flattened or worn down.

How do you remove it?

  1. Unplug the machine or remove the battery.
  2. Turn the floor head over.
  3. Release the bar if the design allows, usually via a cover, a coin slot or clips.
  4. Cut along the length of the wrapped hair with scissors or a seam ripper.
  5. Pull the cut strands free with fingers or tweezers.
  6. Check the end caps and bearings at each end.
  7. Refit and spin the bar by hand to check it turns freely.

Cut along the bar rather than across it, following the groove that most brush bars have for exactly this purpose.

Why do the end caps matter?

Because hair works its way past the bristles and into the bearing at each end, where it winds into a tight felt that eventually stops the bar turning or destroys the bearing.

Many bars have removable end caps. Take them off, clear the hair, and check the bearing spins smoothly. A bar that grinds or feels rough needs replacing.

What tool is best?

A seam ripper, which is designed to cut thread without damaging fabric and is ideal here. Scissors work if used carefully. Some vacuums come with a small cutting tool.

Avoid a knife, which slips easily and can cut the bristles or the bar itself.

Should the bar be washed?

Only if the manual permits it, and never if it contains a motor or electrical contacts, which is the case on many powered heads. Where washing is allowed, use warm water and let it dry completely for a day before refitting.

A damp bar refitted into a head will smell and can corrode the bearings.

What about the belt?

On uprights with a belt driven bar, the belt stretches and perishes over time. A stretched belt slips, which produces a burning rubber smell and a bar that turns weakly or not at all under load.

Belts are inexpensive and usually straightforward to change. Replacing one every year or two on a machine in regular use is normal maintenance rather than a repair.

How often should it be done?

Monthly in a household with long hair or pets, and every couple of months otherwise. It takes five minutes and it is the difference between a vacuum that cleans carpet properly and one that merely passes over it.

What about anti-tangle heads?

Several manufacturers now make heads designed to cut or shed hair as they work, using angled bristles or a comb built into the housing. They reduce the problem considerably rather than eliminating it, and still benefit from an occasional check.

When does a bar need replacing?

When the bristles are worn short, splayed or missing in patches, when the bearings grind, or when the bar is visibly bent. Worn bristles no longer reach into the carpet, so pick up falls even though everything appears to work.

Replacement bars are available for most machines and cost far less than a new vacuum.

Does it matter on hard floors?

A rotating bar can scatter debris on hard floors rather than collecting it, which is why most modern machines allow it to be switched off or use a soft roller head instead. Turning it off on hard floors also reduces wear on the bristles.

What about the groove along the bar?

Most brush bars have a channel running their length, and it is there deliberately so scissors or a seam ripper can be run along it without touching the bristles. Using it makes the job considerably quicker and avoids the risk of cutting the bristles short, which permanently reduces how well the bar agitates carpet.

More Vacuum Cleaners guides · All Products guides